Euphonix System 5 Spezifikationen

Stöbern Sie online oder laden Sie Spezifikationen nach Aufnahmegeräte Euphonix System 5 herunter. Euphonix System 5 Specifications Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 49
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
System 5 Control Surface/Frame
Version 1.0
Part# 840-07576-01
Publish date: October 1999
Euphonix Inc. 220 Portage Avenue Palo Alto , CA 94306
Tel: (650)855-0400 Fax: (650) 855-0410 Web Page: www.euphonix.com
In the interest of continued product development, Euphonix reserves the right to make improvements in this manual and the
product it describes at any time, without notice or obligation.
System 5, S-5, PatchNet, eMix, EuCon, R-1, Studio Hub, , Digital Studio Controller, DSC, CleaR, GainBall, SnapShot,
SnapShot Automation, SnapShot Recall and Total Automation are trademarks of Euphonix Inc.
Seitenansicht 0
1 2 3 4 5 6 ... 48 49

Inhaltsverzeichnis

Seite 1 - Publish date: October 1999

System 5 Control Surface/FrameVersion 1.0Part# 840-07576-01Publish date: October 1999Euphonix Inc. 220 Portage Avenue Palo Alto , CA 94306Tel: (65

Seite 2 - TABLE OF CONTENTS

S5 Control Surface/Frame Manual Page 10 Version 1.0 ©1999 Euphonix, Inc.User Reference - FrameAssembling the S5 FrameTools required:• Hex drivers,

Seite 3

S5 Control Surface/Frame Manual Page 11 Version 1.0 ©1999 Euphonix, Inc.3) After the beam is attached to the leg, the auxiliary leg (12 ft frame onl

Seite 4 - Safety and Precautions

S5 Control Surface/Frame Manual Page 12 Version 1.0 ©1999 Euphonix, Inc.5) Prior to inserting the palm beam (item 7) into the left leg, thread the b

Seite 5 - CE/TUV/UL/CSA

S5 Control Surface/Frame Manual Page 13 Version 1.0 ©1999 Euphonix, Inc.auxiliary leg can help to hold up the beam.7) Insert as many “T” nuts in the

Seite 6 - Component Overview

S5 Control Surface/Frame Manual Page 14 Version 1.0 ©1999 Euphonix, Inc.checked.10) To secure the spread plates into the palm beam ends, pull down

Seite 7 - FRAME SECTION

S5 Control Surface/Frame Manual Page 15 Version 1.0 ©1999 Euphonix, Inc.15) Using a 5/32“ hex driver and 1/4x20/3/8 button head screws (044-07236-0

Seite 8 - Side Panel View

S5 Control Surface/Frame Manual Page 16 Version 1.0 ©1999 Euphonix, Inc.18) If the network, power, and talkback mic cables are not going to enter t

Seite 9 - Dimensions and Weight

S5 Control Surface/Frame Manual Page 17 Version 1.0 ©1999 Euphonix, Inc.System 5 Ethernet/Power Cable Configuration

Seite 10 - User Reference - Frame

S5 Control Surface/Frame Manual Page 18 Version 1.0 ©1999 Euphonix, Inc.System 5 Ethernet Cable HarnessMACHINE ROOMCONSOLEA16-A30A1-A152365(TYP 30 P

Seite 11

S5 Control Surface/Frame Manual Page 19 Version 1.0 ©1999 Euphonix, Inc.CONTROL MODULE SECTION

Seite 12

S5 Control Surface/Frame Manual Page 2 Version 1.0 ©1999 Euphonix, Inc.TABLE OF CONTENTSBox Inventory...

Seite 13

S5 Control Surface/Frame Manual Page 20 Version 1.0 ©1999 Euphonix, Inc.CONTROL MODULES SECTIONPhysical SpecificationsTop View - Control ModulesFram

Seite 14

S5 Control Surface/Frame Manual Page 21 Version 1.0 ©1999 Euphonix, Inc.Filler ModulesCM409F- This is the full-wide blank module for S5 Control surf

Seite 15

S5 Control Surface/Frame Manual Page 22 Version 1.0 ©1999 Euphonix, Inc.Dimensions and WeightModule Weight WidthCM401: 35lbs (16kg) 12”CM402: 35lbs

Seite 16

S5 Control Surface/Frame Manual Page 23 Version 1.0 ©1999 Euphonix, Inc.Control Module Expansion PortGeneral DescriptionOn the back of each System 5

Seite 17

S5 Control Surface/Frame Manual Page 24 Version 1.0 ©1999 Euphonix, Inc.Looking into the FEMALE connector on the module:Looking into a MALE cable co

Seite 18 - DETAIL 'A'

S5 Control Surface/Frame Manual Page 25 Version 1.0 ©1999 Euphonix, Inc.DB25 Electrical Specification:The +5V output on the connector is protected i

Seite 19 - CONTROL MODULE SECTION

S5 Control Surface/Frame Manual Page 26 Version 1.0 ©1999 Euphonix, Inc.Alternate Usage #1:Another way of using these talkback inputs/outputs would

Seite 20 - CONTROL MODULES SECTION

S5 Control Surface/Frame Manual Page 27 Version 1.0 ©1999 Euphonix, Inc.Alternate Usage #2:Another implementation combines the above two approaches

Seite 21 - Filler Modules

S5 Control Surface/Frame Manual Page 28 Version 1.0 ©1999 Euphonix, Inc.User Reference – Control ModulesControl Module SetupOverview of Ethernet IP

Seite 22 - Technical Specifications

S5 Control Surface/Frame Manual Page 29 Version 1.0 ©1999 Euphonix, Inc.Self Test Procedure for CM401, CM402 and CM408(For CM40x Firmware Rev 1.0S)T

Seite 23 - Control Module Expansion Port

S5 Control Surface/Frame Manual Page 3 Version 1.0 ©1999 Euphonix, Inc.Switch Test...

Seite 24

S5 Control Surface/Frame Manual Page 30 Version 1.0 ©1999 Euphonix, Inc.Initiating Self TestEnter self-test by pressing the self-test enter keys sho

Seite 25 - Typical Usage:

S5 Control Surface/Frame Manual Page 31 Version 1.0 ©1999 Euphonix, Inc.Self Test OperationsThe operation of each key on the upper and lower board i

Seite 26

S5 Control Surface/Frame Manual Page 32 Version 1.0 ©1999 Euphonix, Inc.Top Level Test KeysTo enter the 6 different tests, use the keys shown below.

Seite 27 - PICK ANY 4

S5 Control Surface/Frame Manual Page 33 Version 1.0 ©1999 Euphonix, Inc.LED testThe LED test has the following modes;• Toggle upper board LEDs• To

Seite 28 - Control Module Setup

S5 Control Surface/Frame Manual Page 34 Version 1.0 ©1999 Euphonix, Inc.All Switch LEDs ToggleThis switch toggles all the upper board LEDs on and of

Seite 29

S5 Control Surface/Frame Manual Page 35 Version 1.0 ©1999 Euphonix, Inc.Switch TestSwitch test has the following modes;Momentary switch press - This

Seite 30 - Initiating Self Test

S5 Control Surface/Frame Manual Page 36 Version 1.0 ©1999 Euphonix, Inc.Intelligent Display TestDisplay bit test – This test lights up the whole of

Seite 31 - Self Test Operations

S5 Control Surface/Frame Manual Page 37 Version 1.0 ©1999 Euphonix, Inc.Knob Test• Halo Test• Knob value display• Knob meter display• Knob switc

Seite 32 - CM401/CM408

S5 Control Surface/Frame Manual Page 38 Version 1.0 ©1999 Euphonix, Inc.Knob value displayDisplays the hex 0 through FF value of the knob being curr

Seite 33 - • Vegas mode

S5 Control Surface/Frame Manual Page 39 Version 1.0 ©1999 Euphonix, Inc.Fader Test• All fader up• All fader down• Fader cycle test with speed con

Seite 34 - Vegas Mode

S5 Control Surface/Frame Manual Page 4 Version 1.0 ©1999 Euphonix, Inc.Box InventoryDescription Part # QtyS5 Leg Set946-07220-01Leg, Left, Finish

Seite 35 - Key/Exit to main

S5 Control Surface/Frame Manual Page 40 Version 1.0 ©1999 Euphonix, Inc.Fader Test (continued)xxxxxxxxMasterGrand182436421206304854607284Center Stri

Seite 36 - PstCpyGrp

S5 Control Surface/Frame Manual Page 41 Version 1.0 ©1999 Euphonix, Inc.All fader upAll faders all the way upAll fader downAll faders all the way do

Seite 37 - • Expansion port switch test

S5 Control Surface/Frame Manual Page 42 Version 1.0 ©1999 Euphonix, Inc.CPU TestRAM TestThis tests the upper unused portion of the CPU board RAM. W

Seite 38 - Expansion port switch test

S5 Control Surface/Frame Manual Page 43 Version 1.0 ©1999 Euphonix, Inc.PC104 RAM TestThis test writes and reads the whole PC104 RAM and checks for

Seite 39

S5 Control Surface/Frame Manual Page 44 Version 1.0 ©1999 Euphonix, Inc.CM401/CM408RAM TestROM TestPC104 RAM TestExit Test Key/Exitto main*InputDynE

Seite 40

S5 Control Surface/Frame Manual Page 45 Version 1.0 ©1999 Euphonix, Inc.APPENDIX 1Parts ListsSystem 5 Leg Set: Part# 946-07220-01Item# Item Descrip

Seite 41

S5 Control Surface/Frame Manual Page 46 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)000-07194-00 1.5" Grommet 1044-06686-00 5/16-18x.375 B

Seite 42 - CPU Test

S5 Control Surface/Frame Manual Page 47 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)System 5 Frame Set, 6ft: Part# 946-06425-01Item# Item Desc

Seite 43 - PC104 RAM Test

S5 Control Surface/Frame Manual Page 48 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)System 5 Frame Set, 9ft: Part# 946-06840-01Item#Item Descr

Seite 44

S5 Control Surface/Frame Manual Page 49 Version 1.0 ©1999 Euphonix, Inc.Parts List (cont)System 5 Frame Set, 12ft: Part# 946-07160-01Item# Item Des

Seite 45 - APPENDIX 1

S5 Control Surface/Frame Manual Page 5 Version 1.0 ©1999 Euphonix, Inc.7) Servicing – Do not attempt to service the Control Modules beyond those me

Seite 46 - Parts List (cont)

S5 Control Surface/Frame Manual Page 6 Version 1.0 ©1999 Euphonix, Inc.Component OverviewFunctional DescriptionThe System 5 Console consists of a fr

Seite 47 - Item# Item Description Qty

S5 Control Surface/Frame Manual Page 7 Version 1.0 ©1999 Euphonix, Inc.FRAME SECTIONPhysical SpecificationsExploded ViewItem No. Qty Description Par

Seite 48 - Item Description

S5 Control Surface/Frame Manual Page 8 Version 1.0 ©1999 Euphonix, Inc. Side Panel ViewItem No. Qty Description Part No. 6ft Part No. 9ft Part No. 1

Seite 49

S5 Control Surface/Frame Manual Page 9 Version 1.0 ©1999 Euphonix, Inc.Dimensions and WeightHeight: 39.5 inchesWidth: Frame size + 10”Depth:

Kommentare zu diesen Handbüchern

Keine Kommentare