Euphonix R-1 Remote Bedienungsanleitung PDF herunterladen (Seite 11)

Remote Manual Page 11

KVM Extender Hookup Instructions

TOOLS REQUIRED: ¼” Allen Hex Wrench

PROCEDURE:

Cabling at Remote Stand

• Route the following cables through the center post of the Remote stand. Note,

some of these may already be installed as part of the standard remote stand.

Remove any cables that do not appear on this list.

a) Video Cable, 5 ft.

b) RS422 Cable, 5ft.

c) IEC “Y” Jumper Cable M/2F, 6ft.

d) Trackball, p/s 2

e) Mini Keyboard, p/s 2

• At the bottom of the stand, attach cables to the Extender Receiver Unit (820-

06701-00) and the cable tray as shown in page 1 of the installation diagram.

Note that the RS232/422 adapter has been relocated from the rear of the Pilot PC

to the serial port on the Extender Receiver as shown.

Cabling at Pilot PC

• Install the cables for the Transmitter Unit of the Extender (820-6701-00)

according to the instructions included with the Extender. Note that a wall

transformer is included and need only be used on the transmitter side of the

extender.

• Locate the Transmitter Unit of the extender in a secure location.

Installation of Cable Tray

• Attach one end of the 1ft CAT5 cable (0320-6659-00) to the Receiver Unit of

the Extender and the other end to the CAT5 F/F bulkhead connector.

• Using the supplied 3M Recloseable Fastener strip (000-06909-00), secure the

Receiver Unit of the Extender to the cable tray as shown in page 1 of the

installation diagram.

• Bundle the excess length of the remote stand cabling behind the Receiver Unit

and attach the cable tray to the bottom of the remote stand using the two

¼” socket head cap screws which secure the center post at the bottom of the

stand. Tighten securely, making sure that no cables are pinched and that no

cabling sticks out of the cable tray, interfering with the casters.

• Attach 032-06758-00, 20m CAT5 extension cable, to both the receiver and

transmitter units of the extender. The green indicator light should turn on

both units when the transmitter is plugged in and the CAT5 connection is

made.

• Start up the R1 system and verify that all signals are working properly,

including the keyboard, mouse/trackball, video, and remote.

1 2 ... 6 7 8 9 10 11 12 13 14

Keine Kommentare

Euphonix R-1 Remote Bedienungsanleitung Seite 11